RE: [xsl] XSLT 2.0 *and* XSLT 1.0 validation -- how to?

Subject: RE: [xsl] XSLT 2.0 *and* XSLT 1.0 validation -- how to?
From: "Pawson, David" <David.Pawson@xxxxxxxxxxx>
Date: Mon, 25 Oct 2004 10:49:12 +0100
    -----Original Message-----
    From: Michael Kay

    I think XSLT 1.0 did a pretty good job of providing basic
    capabilities for versioning. One wouldn't expect many
    people to be using them when there is only one version of
    the spec out. It might turn out that it was
    over-engineered, but that's probably better than the

Agreed from a 1.0 perspective.
You also said, "I'm less convinced by finer-grained controls.
If it hadn't already been there (on LREs) in 1.0, I doubt we would have added

Is it still a worthwhile addition in 2.0?

regards DaveP


NOTICE: The information contained in this email and any attachments is
confidential and may be privileged.  If you are not the intended
recipient you should not use, disclose, distribute or copy any of the
content of it or of any attachment; you are requested to notify the
sender immediately of your receipt of the email and then to delete it
and any attachments from your system.

RNIB endeavours to ensure that emails and any attachments generated by
its staff are free from viruses or other contaminants.  However, it
cannot accept any responsibility for any  such which are transmitted.
We therefore recommend you scan all attachments.

Please note that the statements and views expressed in this email and
any attachments are those of the author and do not necessarily represent
those of RNIB.

RNIB Registered Charity Number: 226227


Current Thread