Re: [xsl] Pipe Question

[David Carlisle <davidc@xxxxxxxxx>]

>   However, nobody still has answered the question:
>  How do you write the select for a parameter to default to empty, not

Yes they did.

> To: xsl-list@xxxxxxxxxxxxxxxxxxxxxx
> In-reply-to: <8dde156b050608132718ae0565@xxxxxxxxxxxxxx> (message from Karl
> 	Stubsjoen on Wed, 8 Jun 2005 13:27:11 -0700)
> Subject: Re: [xsl] Pipe Question
> Content-Type: text
> Content-Length: 1920
> 
> 
> 
> > Where the "()" select will evaluate to an empty sequence when none was
> > supplied.  I understand that it could be any valid xpath expression.
> 
> I forget whether you are using xslt2 or 1, if using one you can't use ()
> but you can use /.. to swlwct an empty node set.
> 
> 
> 

David

________________________________________________________________________
This e-mail has been scanned for all viruses by Star. The
service is powered by MessageLabs. For more information on a proactive
anti-virus service working around the clock, around the globe, visit:
http://www.star.net.uk
________________________________________________________________________