RE: [xsl] output encoding problem (can't get UTF-8)

["Gabriel K" <gabriel.klappenbach@xxxxxxxxxxxx>]

Ok now I get the document, but guess what: same problem is still there in
the output! Characters E D V look the same crap as before...

set oStream = createobject("Adodb.Stream")
oStream.Type = 2
oStream.Charset = "UTF-8"
oStream.open
oStream.writeText o.document
oStream.position = 0
call transform(oStream)

sub transform(oStream)
   xmlDom.load(oStream)

And if I set charset to something else than "UTF-8", or don't specify it at
all (then it probably defaults to Unicode)I get the error (when loading the
XML):
" Switch from current encoding to specified encoding not supported. '<?xml
version="1.0" encoding="utf-8"?>'"

So I'm really lost now.... there's no problem loading the XML document as
UTF-8, so that's what the IXSLProcessor should have to do the transform
on... XSL should then work in Unicode and output it as specied in the
outermost stylesheet (UTF-8).

Is there anything I can try?

/Gabriel


> -----Ursprungligt meddelande-----
> Fren: Joe Fawcett [mailto:joefawcett@xxxxxxxxxxx]
> Skickat: den 7 augusti 2005 19:41
> Till: xsl-list@xxxxxxxxxxxxxxxxxxxxxx
> Dmne: Re: [xsl] output encoding problem (can't get UTF-8)
>
> ----- Original Message -----
> From: "Gabriel K" <gabriel.klappenbach@xxxxxxxxxxxx>
> To: <xsl-list@xxxxxxxxxxxxxxxxxxxxxx>
> Sent: Sunday, August 07, 2005 3:53 PM
> Subject: RE: [xsl] output encoding problem (can't get UTF-8)
>
>
> I have problems getting this to work.
> When I try to load the XML, MSXML reports the following error:
> "XML document must have a top level element"
>
> This suggests that it can't read the stream properly.
>
> Do you think it matters that the oStream object is passed as a parameter
> in
> a function before it is used in xmlDom.load?
>
> I'm now using:
>
> set oStream = createobject("Adodb.Stream")
> oStream.Type = 2
> oStream.Charset = "Unicode"
> oStream.open
> oStream.writeText o.document
> xmlDom.load(oStream)
>
> (oStream is passed as a sub parameter first though)
> I have also tried writing binary (type = 1 and oStream.write), and charset
> =
> "UTF-8".
>
> Any suggestions?
>
> /Gabriel
>
> After writing to the stream set the position to the start:
> oStream.position = 0
>
> Joe