[Virtools] deleting copied objects

["H.D. Case" <casemon@hotmail.com>]

I'm using Object Copy BB to copy an object then I have it follow a Curve. I
wish to delete the copied object when it reaches the end of the curve.

This is basically a loop. I can then re-use the schematic on several curves
using only one version of the Object.

Is there a way to delete the copied object automagically at the end of the
loop (on Curve Follow - Out) without knowing it's name? As Virtools does the
naming when the object is copied, the name will change depending on the
number of Curves that have Copied Objects on them. Or should I use Object
Rename and have each curve be hardcoded? Do either, ObjectCopy or Object
Rename, ensure only unique names are made?
...............................................................
Distributed via the virtools-user-group list: http://www.theswapmeet.com/numl.html
To reply to the list instead of its author, use "Reply to All"
To unsubscribe: send "unsubscribe virtools-user-group" to Majordomo@lists.theswapmeet.com
To subscribe: send "subscribe virtools-user-group" to Majordomo@lists.theswapmeet.com
To post a message: send it to virtools-user-group@lists.theswapmeet.com
...............................................................

---

Follow-Ups:

• Re: [Virtools] deleting copied objects
• From: "David Callele" <d.callele@home.com>

---

• Prev by Date: [Virtools] problems with the listserv?
• Next by Date: Re: [Virtools] chrome surface
• Prev by thread: Re: [Virtools] chrome surface
• Next by thread: Re: [Virtools] deleting copied objects
• Index(es):
  • Date
  • Thread

---