Ah! Another Bostonian, I see! (I work right around the corner from MIT :)
I will definetely keep you in mind when I get to the cart development
stage. Do you have some screenshots of your boards? What are you doing for
the necessary inversion of that 1 line?
Joe
At 05:36 PM 2/28/2001 -0500, you wrote:
>In message <200102281555.KAA15827@xxxxxxxxxxxxxxxxxxxxxxxxxxx>, Joe Grand
write
>s:
>>Regarding making the carts, Hozer does a great job, but for myself, I was
>>thinking of churning out some custom PCBs for the inside of cart cases
>
>
>I would recommend going with Hozer...There will be a bit of learning curve
>involved and Randy already does a good job. If you do go the custom board
>route, I recommend buying some of my boards, which can be used for anything
>up to 16k. Small board runs are quite expensive...with the setup fees,
you'll
>wind up paying about $3.5 for each board in quantities of 100. Plus the
parts
>needed. Ordering from me will save you $$$, and hassle. I can give you the
>blank pcb, or the parts to build the boards, or I can build the boards for
>you...whichever is more convenient.
>
>Let me know...
>-Chris
-
Archives (includes files) at http://www.biglist.com/lists/stella/archives/
Unsub & more at http://www.biglist.com/lists/stella/
