I think there was orientation and banking problems in the "position on
curve" building block, as you describe it, and I know those problems are solved
in the beta version of the new version.
... well it's not very helpful, but I encounter the same problem ... so you
did nothing bad :)
----- Original Message -----
Sent: Thursday, November 09, 2000 6:32
PM
Subject: [Virtools] 'position on curve'
acting unexpectedly
hi, I have another question or two if you don't
mind :-)
I have an object following a path, I'm using the
'position on curve'
behaviour block. I have the 'follow'
parameter checked and 1,0,0
as the follow axis (which should be forward for
the object), but it
seems as if it's using the Y-axis to
follow the path, as the top of
the object (and the green axis) points in the
direction of the curve.
Can anyone give me
a suggestion as to what the problem might
be? I have tried all axes and I get the
right direction on one (0,-1,0),
but this rotates
the object 90 degrees anti-clockwise.
A second question. Most of my links have a
delay of zero.
Is there a way to set the default link delay to
be zero instead
of
one?
Thanks.
Padraig