[Date Prev][Date Next][Thread Prev][Thread Next]
[Date Index] [Thread Index]
[Monthly Archives] [List Home]

AW: [Virtools] Debouncing of input signals

Hi Patrick,

thank you very much for your support but it doesn't work. The problem using
the collision detection (like in my script) is, that you haven't a continous
input stream. The BB sends you lots of input signals, each time a collision
is detected. So I need a solution, where I get one signal when the collision
happens. After that the BB must "sleep" for a few seconds. Only when this
"Delay-Time" is over, the BB can be activated next time.

Kai

-----Ursprungliche Nachricht-----
Von: owner-virtools-user-group@lists.theswapmeet.com
[mailto:owner-virtools-user-group@lists.theswapmeet.com]Im Auftrag von
Patrick Hogenboom
Gesendet: Mittwoch, 27. Juni 2001 18:54
An: Virtools User Group mailing list (E-mail)
Betreff: RE: [Virtools] Debouncing of input signals


Hi Kai,

Here's a little example of turning a continuous input stream into a one-time
event.
A picture says more than 1000 words, so here's a screenshot ;)

Greetings, Patrick

...............................................................
Distributed via the virtools-user-group list: http://www.theswapmeet.com/numl.html
To reply to the list instead of its author, use "Reply to All"
To unsubscribe: send "unsubscribe virtools-user-group" to Majordomo@lists.theswapmeet.com
To subscribe: send "subscribe virtools-user-group" to Majordomo@lists.theswapmeet.com
To post a message: send it to virtools-user-group@lists.theswapmeet.com
...............................................................
Follow-Ups: References: